Service Procedure For Inspection:

SERVICE PROCEDURE FOR INSPECTION: (Refer to Bulletin 90-C-9 for replacement procedure)

Refer to 1990 Riviera and Reatta Service Manual - Section 3F4

1. Read precautions on handling SIR Inflator Module (pages 2 and 3 of Section 3F4).

2. Disable the SIR system (page 2 of Section 3F4).


3. Remove the four (4) screws retaining the Inflator Module from steering wheel assembly.

4. Check back side of Inflator Module for bar code AB96371EKAAH53.

5. a. If bar code matches, replace Inflator Module. Refer to replacement procedure (pages 4 and 5 of Section 3F4).

b. If bar code is not present, replace Inflator Module. Refer to replacement procedure (pages 4 and 5 of Section 3F4).

c. If bar code does not match, reinstall four (4) screws.

6. Enable the SIR system (page 3 of Section 3F4).

7. Install Campaign Label.

IMPORTANT:
If replacement is required after inspection, please hold vehicle until replacement is completed. Owner should be provided a loaner, if desired.