Ignition Coil: Service and Repair

Ignition Coil/Module Service:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Four-terminal connector at ignition coil module.
3. Secondary ignition coil wire.
4. Ignition coil connectors.
5. Bolt and stud retaining bracket.
6. Ignition coil module/ignition coil and bracket. Do not wipe silicone grease from back of bracket.
7. Ignition coil from bracket. Drill out rivets.

INSTALL OR CONNECT

NOTE: If a new bracket is installed, a package of silicone grease for cooling is provided. Spread grease on metal face of bracket before installation.

1. Ignition coil to bracket using bolts and nuts provided with coil.

Tighten
Bolts to 2.8 Nm (25 lb. in.).

2. Bracket with bolt and stud.

Tighten
Bolt and stud to 25 Nm (18 lb. ft.).

3. Ignition coil connectors.
4. Secondary ignition coil wire.
5. Four-terminal connector at ignition coil module.
6. Negative battery cable.

Tighten
Battery cable bolt to 15 Nm (11 lb. ft.).