Infl Rst Steering Wheel Module Replacement

REMOVAL PROCEDURE

1. Disable the SIR system. Refer to Disabling the SIR System.






2. Insert a flat-bladed screwdriver into one of the four openings in the back of the steering wheel.
3. Turn the screwdriver counterclockwise to disengage the spring from the slot in the module.
4. Pull the module gently away from the steering wheel.
5. Repeat the previous three steps for the remaining openings.






6. Remove the inflator module from the steering wheel.
7. Remove the Connector Position Assurance (CPA) from the driver frontal air bag electrical connector.
8. Disconnect the electrical connector from the back of the module.
9. Rotate the horn contact lead counterclockwise 1/4 turn in order to remove the horn contact lead from the steering column cam tower.

INSTALLATION PROCEDURE






1. Install the horn contact lead to the steering column cam tower.
2. Connect the electrical connector to the back of the module.
3. Install the CPA to the module electrical connector.
4. Install the module to the steering wheel by pushing on both the right and left sides of the inflator module until the retaining springs engage.
5. Enable the SIR system. Refer to Enabling the SIR System.