Results of Incorrect Operation

An ignition control circuit that is open, grounded, or short to voltage will set an ignition control circuit DTC. If a fault occurs in the IC output circuit when the engine is running, the engine will experience a misfire. DTCs P0351-P0358 will set when a malfunction is detected with an ignition control circuit. When an ignition control DTC sets, the PCM will disable the injector for the appropriate cylinder.

The PCM uses information from the engine coolant temperature sensor in addition to the RPM in order to calculate spark advance values as follows:
^ High RPM equals more advance
^ A cold engine equals more advance
^ Low RPM equals less advance
^ A hot engine equals less advance

Therefore, detonation may be caused by high resistance in the engine coolant temperature sensor circuit. Poor performance may be caused by low resistance in the engine coolant temperature sensor circuit.

If the engine cranks but will not run, or immediately stalls, the Engine Cranks But Will Not Run diagnostic table must be used to determine if the failure is in the ignition system or the fuel system. If DTC P0300, P0341, P0342, P0343, P0335, or P0336 is set, the appropriate diagnostic trouble code table must be used for diagnosis.