Engine, A/T Controls - Harsh 1-2/2-1/5-4 Shifts
TSB 09-15-808/10/09
5.4L 3V 6R80 - HARSH 1-2 UPSHIFT - HARSH 2-1
DOWNSHIFT WHILE COASTING - HARSH DOWNSHIFT
TO 4TH GEAR - INTERMITTENT P0741
FORD:
2009 Expedition
LINCOLN:
2009 Navigator
ISSUE
Some 2009 Expedition and Navigator vehicles equipped with 5.4L 3V engine may exhibit symptoms during warm-up: a harsh 1-2 upshift, harsh 2-1 downshift while coasting 15 MPH (24 Km/h). A harsh downshift into 4th gear at highway speeds 45-70 MPH (72-113 Km/h) may also be experienced. Some vehicles may have a diagnostic trouble code (DTC) P0741 torque converter performance code present or stored.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
NOTE
MECHATRONIC REPAIR/REPLACEMENT IS NOT
AUTHORIZED FOR THIS ISSUE.
1. Install IDS/PDS or equivalent and ID vehicle.
2. Update the Powertrain Control Module/Transmission Control Module (PCM/TCM) calibration using IDS release 61.15 and higher or 62.03 and higher. This new calibration is not included in the VCM 2009.5 DVD. Calibration files may also be obtained at the website.
NOTE
THE TCM CANNOT BE INDEPENDENTLY REPROGRAMMED, REPROGRAM USING THE PMI FUNCTION TO ENSURE THAT ENGINE AND TRANSMISSION CALIBRATIONS ARE UPDATED TO THE LATEST LEVEL SIMULTANEOUSLY.
a. Verify that the TCM Calibration shows AL3P-7J104-AB part number after reprogramming is complete.
b. Select the following from the IDS tool:
(1) Toolbox.
(2) Powertrain.
(3) OBD Test Modes.
(4) Mode Level 9 Vehicle Info.
(5) TCM Cal Part Number.
NOTE
IT IS CRITICAL THAT TCM KEEP ALIVE MEMORY (KAM) BE CLEARED FOR TSB TO BE FULLY AFFECTIVE
3. Clear TCM KAM and adaptive tables.
a. Using IDS:
(1) Open Toolbox.
(2) Choose Powertrain.
(3) Choose Reset KAM.
(4) Choose TCM.
b. Using PDS:
(1) Choose all Tests and Calibrations.
(2) Scroll down the menu and choose reset TCM KAM.
NOTE
FOR PDS, RESET TCM KAM IS NOT THE SAME AS CLEAR TRANSMISSION ADAPTIVE TABLES, WHICH IS UNDER THE POWERTRAIN - TRANSMISSION MENU TREE.
NOTE
DISCONNECTING THE BATTERY WILL NOT CLEAR THE TCM KAM. IT IS CRITICAL THAT TCM KAM BE CLEARED PRIOR TO RELEARNING THE ADAPTIVE TABLES FOR THE TRANSMISSION.
NOTE
DO NOT CLEAR THE PCM KAM.
4. Verify that the transmission fluid temperature (TFT) PID is above 175° F (79° C). If it is not at 175° F (79° C), drive unit approximately 3 miles (5 Km) to reach temperature.
NOTE
TFT MUST BE AT 175° F (79° C) OR ABOVE BEFORE PROCEEDING TO STEP 5.
NOTE
PERFORM ADAPTIVE SHIFT STRATEGY LEARN ON LEVEL SURFACE ROAD.
5. Drive unit to perform adaptive shift strategy learn.
a. Accelerate from a stopped position with light throttle to 15 MPH (24Km/h) and remove foot from accelerator pedal.
b. Brake very gently to a complete stop (allow at least six (6) seconds).
c. Repeat steps (a-b) five (5) times in the dealership parking lot or similar setting.
d. Accelerate from rest with light throttle ensuring that the 1-2, 2-3 and 3-4 shifts occur at engine speeds between 1700-2000 RPM.
e. Continue to accelerate until you achieve 50 MPH (80 Km/h) or the 5-6 upshift.
f. Brake gently to a complete stop and hold foot on brake for ten (10) seconds.
g. Repeat steps (d-f) three (3) times.
NOTE
SEVERAL DAYS OF DRIVING ARE REQUIRED FOR THE TRANSMISSION TO FULLY ADAPT.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION DESCRIPTION TIME
091508A 2009 Expedition, Navigator 1.0 Hr.
6R80 Transmission: Check
DTCs, Reprogram The
PCM And TCM, Includes
Time To Clear The TCM
KAM And Perform Road
Tests (Do Not Use With
12650D, 12651D,
12651D4)
DEALER CODING
CONDITION
BASIC PART NO. CODE
RECAL 42
Disclaimer