Timing Cover: Service and Repair

REMOVAL
1. Remove the accessory drive belts.
2. Remove the three water pump pulley retaining bolts and the water pump pulley (8509).
3. Remove the crankshaft pulleys.
4. Remove the four bolts and the upper engine front cover.
5. Remove the two bolts and the lower engine front cover.

INSTALLATION
^ To install, reverse the removal procedure.
^ Tighten the water pump pulley retaining bolts to 49-61 Nm (36-45 ft. lbs.).
^ Tighten the upper and lower engine front cover bolts to 8-11 Nm (71-97 inch lbs.).