Setting of Limit Switch
FRONT DOOR GLASS AND REGULATORSetting of Limit Switch
If any of the following work has been done, set the limit switch (integrated in the motor).
- Removal and installation of the regulator.
- Removal and installation of the motor from the regulator.
- Operate the regulators as a unit.
- Removal and installation of the glass.
- Removal and installation of the glass stopper.
Resetting
After installing each component to the vehicle and adjusting the glass fitting, follow the steps below.
1. Raise the glass to the top position.
2. While pressing and holding the reset switch, lower the glass to the bottom position.
3. Release the reset switch, and check that the reset switch returns to the original position, and then raise the glass to the top position.
CAUTION: Do not operate the glass automatically to raise the glass to the top position.
FITTING INSPECTION
- Check that the glass is securely fit into the body side weatherstrip.
- Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and check that the clearance to the weatherstrip is parallel. If the clearance between the glass and weatherstrip is not parallel, adjust glass fitting.