Drain and Refill
Drain and RefillCAUTION:
^ Refill with new brake fluid "DOT3".
^ Do not reuse drained brake fluid.
^ Do not let brake fluid splash on painted surfaces of body. This might damage paint, so when splashing it on the surfaces, immediately wipe off them and wash it away with water.
^ Before servicing, disconnect electrical connectors of VDC/TCS/ABS control unit or battery negative terminal.
1. Connect a vinyl tube to bleed valve.
2. Depress brake pedal, loosen bleed valve, and gradually remove brake fluid.
3. Make sure there is no foreign material in reservoir tank, and refill with new brake fluid.
4. Rest foot on brake pedal. Loosen bleed valve. Slowly depress pedal until it stops. Tighten bleed valve. Release brake pedal. Repeat this process a few times, then pause to add new brake fluid to master cylinder. Continue until new brake fluid flows out.
5. Bleed Air. Refer to "Bleeding Brake System"