Main Bearing Cap
Main Bearing Cap
Tighten lower cylinder block bolts (No. 1 to 16) in numerical order as shown in the figure.
Torque 35.3 Nm (3.6 kg-m, 26 ft-lb)
Turn lower cylinder block bolts (No. 1 to 16) 90 degrees clockwise (angle tightening).
Completely loosen lower cylinder block bolts (No. 1 to 16).
Torque 0 Nm (0 kg-m, 0 ft-lb)
Tighten lower cylinder block bolts (No. 1 to 16) in numerical order as shown in the figure.
Torque 35.3 Nm (3.6 kg-m, 26 ft-lb)
Turn lower cylinder block bolts (No. 1 to 16) 90 degrees clockwise (angle tightening).
Tighten lower cylinder block bolt (No. 17 to 26).
Torque 22.0 Nm (2.2 kg-m, 16 ft-lb)
After installing lower cylinder block bolts, make sure that crankshaft can be rotated smoothly by hand.
Check the crankshaft end play.
LOWER CYLINDER BLOCK BOLT OUTER DIAMETER
Measure the outer diameters (c), (d) at two positions as shown in the figure.
a 20 mm (0.79 in)
b 30 mm (1.18 in)
e 10 mm (0.39 in)
If reduction appears in (a) range, regard it (d) as (c).
Limit [(c) - (d)] 0.11 mm (0.0043 in)
If it exceeds the limit (large difference in dimensions), replace lower cylinder block bolt with new one.