Transmission Mount: Service and Repair

Transmission Support Insulator

Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

3. CAUTION: During this procedure the transmission crossmember is removed, make sure the transmission is correctly supported to avoid damaging associated components.

Using a transmission jack, support the transmission.

4. Remove the transmission support crossmember damper.

^ Remove the 3 bolts.





5. Remove the transmission support crossmember.

^ Remove the 6 bolts.





6. NOTE: Do not disassemble further if the component is removed for access only.

Remove the transmission support insulator.

^ Remove the 2 bolts.





Installation
1. Install the transmission support insulator.

^ Tighten the bolts to 25 Nm (18 lb.ft).

2. Install the transmission support crossmember.

^ Tighten the bolts to 48 Nm (35 lb.ft).

3. Install the transmission support crossmember damper.

^ Tighten the bolts to 10 Nm (7 lb.ft).

4. Remove the transmission jack.
5. Install the exhaust system.