Precautions For Transfer Assembly and Transfer Control Unit Replacement

Precautions for Transfer Assembly and Transfer Control Unit Replacement
When replacing transfer assembly or transfer control unit, check the 4WD shift indicator lamp as follows.
1. Turn ignition switch ON.
2. Check 4WD shift indicator lamp is turned ON for approximately 1 second.
^ If OK, the position between transfer assembly and transfer control unit is correct.
^ If NG, the position is different between transfer assembly and transfer control unit.
Adjust the position between transfer assembly and transfer control unit.

METHOD FOR POSITION ADJUSTMENT
1. Start engine. Run the engine for at least 10 seconds.
2. Stop vehicle and move A/T selector lever to N position with brake pedal depressed. Stay in N for at least 2 seconds.
3. Turn 4WD shift switch to 2WD position. Stay in 2WD for at least 2 seconds.
4. Turn ignition switch OFF.
5. Start engine.
6. Erase self-diagnosis.
7. Check 4WD shift indicator lamp.
If 4WD shift indicator lamp does not indicate 2WD, install new transfer control unit and retry the above check.