Base Audio

AV CONTROL UNIT

Removal and Installation


REMOVAL


CAUTION:
- Before replacing AV control unit, perform "READ CONFIGURATION" to save or print current vehicle specification. For details, Base Audio.
- Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the ignition switch OFF
NOTE:
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.
1.Remove disk eject switch. Base Audio.
2.Remove two harness clips mounted to the bracket.
3.Remove four mounting screws and pull the AV control unit together with the brackets.
4.Disconnect connectors to remove AV control unit and bracket from the vehicle as a single unit.
5.Remove bracket screws to remove AV control unit.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Be sure to perform "WRITE CONFIGURATION" when replacing AV control unit. For details, Base Audio.