Rear Wheel

WARNING:
^ ALWAYS PERFORM FOLLOWING PROCEDURE ON A FLAT SURFACE.
^ MAKE SURE THAT NO ONE IS IN FRONT OF THE VEHICLE BEFORE PUSHING IT.

1. Bounce rear of vehicle up and down to stabilize the posture.
2. Push the vehicle straight ahead about 5 m (16 ft.).





3. Put a mark on base line of the tread (rear side) of both tires at the same height of hub center. This mark is a measuring point.





4. Measure distance "A" (rear side).
5. Push the vehicle slowly ahead to rotate the wheels 180 degrees (1/2 turn).

NOTE: If the wheels have rotated more than 180 degrees (1/2 turn), try the above procedure again from the beginning. Never push vehicle backward.

6. Measure distance "B" (front side). Total toe-in is (A - B).