Traction Control Module: Service and Repair

ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)





REMOVAL
1. Disconnect battery negative terminal.
2. Remove windshield wiper and linkage assembly.
3. Drain brake fluid.
4. Discharge the A/C refrigerant.
5. Disconnect and remove high-pressure and low-pressure A/C pipes to allow access to ABS actuator and electric unit (control unit). Refer to ATC-120, Components. Exploded Views
6. Disconnect harness connectors from ABS actuator and electric unit (control unit).
7. Disconnect brake pipes.
8. Remove bolts and ABS actuator and electric unit (control unit).

INSTALLATION

CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system.

1. Position ABS actuator and electric unit (control unit) in vehicle.
2. Connect brake pipes and bolts temporarily.
3. Tighten bolts and brake pipes to specification.
4. Connect ABS actuator and electric unit (control unit) harness connectors.
5. Install and connect high-pressure and low-pressure A/C pipes. Refer to ATC-120, Components.
6. Install windshield wiper and linkage assembly.
7. Connect battery negative terminal.
8. Evacuate and recharge the A/C system.
9. Adjust the steering angle sensor.