Oil Level Sensor: Service and Repair

Engine Oil Level Sensor and/or Switch Replacement

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the engine oil drain plug in order to drain the engine oil.
3. Disconnect the oil level sensor electrical connector.





4. Remove the bolt from the oil level sensor.
5. Remove the oil level sensor from the oil pan.

Installation Procedure





1. Install the engine oil level sensor to the oil pan.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the engine oil level sensor bolt.
- Tighten the bolt to 9 Nm (80 inch lbs.).
3. Connect the oil level sensor electrical connector.
4. Install the engine oil drain plug.
- Tighten the engine oil drain plug to 30 Nm (22 ft. lbs.).
5. Lower the vehicle.
6. Fill the engine with new engine oil.
7. Start the engine and inspect for oil leaks.