Modulator Gear Cover Replacement

REMOVAL PROCEDURE
1. Remove the Brake Modulator Assembly.
2. Remove six Torx head screws (5) that retains the gear cover to the hydraulic modulator/motor pack assembly (1).
3. Remove the gear cover (4).





INSTALLATION PROCEDURE
1. Install the gear cover (4) onto the modulator/motor pack assembly (1).
2. Install the six Torx head screws (5).
^ Tighten the Torx screws (5) to 4 Nm (36 inch lbs.).

NOTICE: Refer to Service Precautions.

3. Install the Brake Modulator Assembly.