Changing the Automatic Door Lock Operation Mode

Perform the following procedure to change the automatic door lock operation mode:
1. Turn off the IP dimmer switch.
2. Turn the ignition switch to the OFF position.
3. Remove the MALL PGM Fuse.
4. Turn the ignition switch to the ACC position.
^ The Body Control Module (BCM) sounds the chime a number of times equivalent to the BCM type installed on the vehicle (1, 2, 3, or 4 chimes).
^ Now the BCM has entered the feature customization mode.
5. To change the automatic door lock operation mode, press and release the LOCK on either door lock switch.
^ The BCM sounds the chime a number of times equivalent to the automatic door lock operation mode. A transition past mode 4 repeats the sequence starting with mode 1.

The automatic door lock operation modes are as follows:
^ Mode 1: Shift out of park lock, ignition off unlock, and shift into park unlock are disabled.
^ Mode 2: Shift out of park lock is enabled.
^ Mode 3: Shift out of park lock and ignition off unlock are enabled.
^ Mode 4: Shift out of park lock and shift into park unlock are enabled.

To exit and save the current customization mode:
1. Turn the ignition switch to the OFF position.
2. Reinstall the MALL PGM Fuse.

If unable to change locking modes, refer to Table 13 for diagnosis and repair. Table 13 Cannot Change/Update Feature Customization Modes