Installing

Installing drive plate for converter
1. Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all M1 0 x 25 fastening screws (8).
2. Align toothed segment 9538/1 and tighten fastening screw again.
3. Screw in and tighten fastening screws in diagonally opposite sequence. Initial tightening 25 (19) Nm (ft. lbs.); Final tightening - torque angle 120°
4. Remove toothed segment.

Subsequent work for drive plate for converter
1. Refit Tiptronic transmission.
2. Install engine.