Accessory Speed Control - Revised

91saab02

CATEGORY
Accessories

SECTION PAGE
19 25
ISSUE CODE
03/91-0092 936


Subject: Accessory Speed Control
Installation

Application: 900 Models, 1991-1/2 -


As a running change during 1991 900 model production, the three 29-pin electrical connectors have been replaced by three 33-pin connectors (see PSI 03/91-0094). The new connectors offer improved pin connections and the ability to lock the two sides of the connector housing together. The change to the new style connectors also affects the installation of the accessory speed control kit, P/N 02 44 681, in these models.

Four (4) male spade connectors, P/N 41 15 457, and an instruction sheet have been added to all accessory speed control kits in Saab's spare parts stock. This will enable the speed control kit to be modified for installation in models with the new 33-pin connectors.

For any kits in a dealer's parts inventory that do not contain the necessary pin connectors and installation sheet, see the procedure below if the kit is to be installed on cars with the upgraded connectors.


Affected Cars:

VIN M5001704-
VIN M7010507-


Parts Required:

Pin connector (qty 4) P/N 41 15 457


Electrical Pin Connector Installation Procedure

The following steps should be performed in place of step 29 of the speed control installation instructions.

Figure 1:

1. Cut off the four round pin connectcrs on the BN (Brown), GY (Grey), OG (Orange), and RD (Red) wires from the speed control wiring harness.

2. Fit a flat pin connector, P/N 41 15 457, to each of the wires.

3. Separate the two halves of the blue 33-pin connector.

4. Fit the speed control wiring harness pins into the 33-pin connector as shown.

5. Reconnect the two halves of the 33-pin connector.

Continue with the installation instructions supplied in the kit.