Assembly

FRONT BUSHING
To reassemble, reverse disassembly procedures.

CAUTION: Install front bushing in correct direction, as shown in figure.

REAR BUSHING
1) Install rear bushing to transverse link and align aligning marks scribed on the two.
2) Tighten self-locking nut.

CAUTION:
- Discard loosened self-locking nut and replace with a new one.
- While holding rear bushing so as not to change position of aligning marks, tighten self-locking nut.

Tightening torque:
196 ± 25 Nm (20.0 ± 2.5 kg-m, 145 ± 18 ft-Ib.)