Installation

Installation

NOTE:
^ The following procedure indicates the LH side.
^ For the RH side, perform the same procedure as the LH side.

1. Installation of steering knuckle LH
(1) Install the steering knuckle LH with 2 bolts and 2 new nuts.
Standard value:T=155Nm {1581kgf-cm} {3,483.86cm-lbf}
2. Installation of front suspension lower arm ASSY LH
(1) Install the front suspension lower arm ASSY LH with the nut.
Standard value:T=51Nm {520kgf-cm} {1,146.05cm-lbf}
(2) Install a new cotter pin.
3. Installation of tie-rod end SUB-ASSY LH
(1) Install the tie-rod end SUB-ASSY LH to the steering knuckle LH with the nut.
Standard value:T=27Nm {275kgf-cm} {606.55cm-lbf}
(2) Install a new cotter pin.

CAUTION:
When aligning the clip holes after tightening the castle nut, tighten the castle nut further but within 60°.

4. Installation of disc brake dust cover FR LH
(1) Install the front disc brake dust cover to the steering knuckle with 3 bolts.
Standard value:T=18Nm {184kgf-cm} {405.38cm-lbf}
5. Installation of front axle hub & bearing ASSY LH
6. Inspection and adjustment of front wheel alignment