Front Suspension

Stabilizer Shaft Link Replacement

Special Tools

EN-45059 - Angle Meter

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Remove the stabilizer shaft link nuts.
4. Remove the stabilizer shaft link from the stabilizer shaft and lower control arm.

Installation Procedure




1. Install the stabilizer shaft link into the stabilizer shaft and lower control arm.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Using the EN-45059 - meter and a torque wrench, tighten the nuts to:

* First Pass: 60 Nm (44 lb ft).
* Final Pass: plus 30 degrees.

3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
4. Lower the vehicle.