DSC/RSC Sensor Initialization Procedure
DSC/RSC SENSOR INITIALIZATION PROCEDUREWarning
^ Unless the initialization procedure of the combined sensor is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the Initialization procedure to ensure DSC/RSC operation if the combined sensor and DSC/RSC HU/CM have been removed or replaced.
1. Inspect the wheel alignment and inflation pressure.
^ If there is any malfunction, adjust the applicable part.
2. Park the vehicle on level ground.
3. Turn the ignition switch off.
4. Connect the M-MDS to the DLC-2 connector.
5. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
^ When using the IDS (laptop PC)
1. Select the "Toolbox" tab.
2. Select "Chassis".
3. Select "ABS/DSC".
4. Select "Sensor Initialization".
^ When using the PDS (Pocket PC)
1. Select "Module Test".
2. Select "ABS".
3. Select "Datalogger".
4. Select "SSR_ INTL".
6. Perform the initialization according to the directions on the screen.