Extension Housing: Service and Repair

Part 1 Of 2:

Part 2 Of 2:

DISASSEMBLY
Disassemble in the order indicated in the illustration.

ASSEMBLY
- Assemble in the reverse order of disassembly indicated in the illustration, referring to the following notes:





Rod Cover (11)
1. Apply transmission oil to the rubber bushings on the rod cover.
2. Install the rod cover with the mark facing forward





Rod Pin (5)
^ Install a new roll pin into the control rod end. The split in the roll pin must be facing in the direction shown in the illustration.

Select-Lock Spindle, Spring, And Spring Cap (2)
1. Install the select-lock spindle, spring, and spring cap. Tighten to 8 - 10 Nm (70 - 95 inch lbs.).
2. Push the select-lock spindle down by pushing on the control rod. This will ensure that the steel ball correctly engages the select-lock spindle.