Installation

STEERING COLUMN: STEERING COLUMN ASSEMBLY:

INSTALLATION

1. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY (for TMC Made)
(a) Align the matchmarks on the steering intermediate shaft assembly and the steering column assembly.

(b) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
2. INSTALL STEERING COLUMN ASSEMBLY (for TMC Made)

(a) Install the steering column assembly with the bolt and 2 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
(b) Connect the connectors and wire harness clamps to the steering column assembly.

(d) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)

(e) Install the clamp to the steering column hole shield.
3. INSTALL STEERING POST ASSEMBLY (for TMMK Made)

(a) Install the steering post assembly with the bolt and 2 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
(b) Connect the connectors and wire harness clamps to the steering post assembly.

(d) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)

(e) Install the clamp to the steering column hole shield.
4. INSTALL NO. 1 AIR DUCT

(a) Engage the 2 claws to install the No. 1 air duct.
5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
6. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

(a) Install the turn signal switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.
(b) Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.
7. INSTALL STEERING COLUMN COVER

(a) Engage the claw to install the upper steering column cover.

(b) Engage the 2 claws to install the lower steering column cover.
(c) Install the 2 screws.
8. ADJUST SPIRAL CABLE SUB- ASSEMBLY (Installation)

9. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the matchmarks on the steering wheel assembly and steering main shaft.
(b) Install the steering wheel assembly set nut.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
(c) Connect the connectors to the spiral cable sub-assembly.
10. INSPECT STEERING WHEEL CENTER POINT
11. INSTALL STEERING PAD (Installation)

12. INSPECT STEERING PAD (Installation)

13. INSTALL NO. 2 LOWER STEERING WHEEL COVER (Installation)

14. INSTALL NO. 3 LOWER STEERING WHEEL COVER (Installation)

15. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (Installation)

16. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) (Installation)

17. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) (Installation)

18. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (Installation)

19. INSTALL FRONT DOOR SCUFF PLATE LH (Installation)

20. INSTALL FRONT WHEEL LH
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
22. INSPECT SRS WARNING LIGHT

HINT: (Diagnosis System)